Quartz Analog Chronographs 1/4 Of A Second; Includes Formula Sportiva (Sf 202.1, 202.2) Quartz Chronograph Models - SCUDERIA FERRARI Pit Crew Operating Instructions Manual

QUARTZ ANALOG CHRONOGRAPHS 1/4 OF A SECOND

with center-mounted chronograph quarter-of-a-second hand, small chronograph minutes counter and seconds hand, and date.
H
E
C
Figure A
1, 2, 3 – Crown positions
Button A – Start/Stop
Button B – Reset
H – Hour Hand
M – Minute Hand
C – Chronograph 1/4-of-a-Seconds Hand
S – Small Seconds Hand
E – Chronograph Minutes Counter
D – Date Display
These chronograph models feature a center-mounted chronograph
1/4-of-a-second hand, small minute counter, small seconds hand and
date display. They can be used to time an event up to 60 minutes in
duration to the nearest quarter of a second.
To set the TIME:
1. Pull crown out to position 2; watch (small seconds hand S) stops.
2. Turn crown clockwise to set hour H and minute M hands to de-
sired time.
3. Push crown back in to position 1; watch (small seconds hand S)
restarts.
To set the DATE:
1. Pull crown out to position 2.
2. Turn crown clockwise to set date D.
IMPORTANT: If date D is set when time is between about 9:00 PM
and 1:00 AM, the date may not change automatically on the
following day.
3. Push crown back in to position 1.
To operate the CHRONOGRAPH:
This chronograph is able to measure and display time in
1/4-second increments up to a maximum of 60 minutes.
It will stop automatically after running continuously for 60 minutes.

Includes Formula Sportiva (SF 202.1, 202.2) quartz chronograph models

M
A
S
1 – 2 – 3
B
D
Legend
Simple chronograph functions:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph.
3. Press button B to reset chronograph to zero.
Accumulated time functions:
To measure the combined time of a series of shorter events:
1. Press button A to start chronograph.
2. Press button A a second time to stop chronograph and read
elapsed time.
3. Press button A again to resume measurement.
4. Press button A a fourth time to stop chronograph again, and
read new elapsed time.
NOTE: Each time you stop chronograph, chronograph hands will
indicate total accumulated time.
5. Repeat steps 1 and 2 to add each additional interval of time.
6. After you have taken your final accumulated time reading,
press button B to reset chronograph hands to zero.
To RESET Chronograph Hands:
After changing the battery, or in the event of an error, the
chronograph hands can be re-aligned to zero if necessary by
following these steps:
1. Pull crown out to position 3.
2. Press button A to set chronograph 1/4-of-a-second hand C to
zero; to advance hand C rapidly, press and hold button A.
NOTE: Chronograph minute hand E is synchronized automatically
with chronograph 1/4-of-a-second hand C.
3. Once chronograph hands C and E have been reset to zero
position, reset the time and push crown back into position 1.