Table of Contents
Advertisement
19. NETWORK
Selects Network Display as the input
signal source.
20. BLANK
Used to hide the screen picture.
21. FREEZE
Freezes the projected image.
22. LAMP MODE
Press to display OSD menu to select
desired lamp mode.
23. LIGHT
Press to open backlight of remote
controller.
24. ID SET
Press to set remote ID.
Press ID SET for three seconds. The
POWER indicator on the remote control
blinks, then press 01~99 to designate an
ID.
Press CLEAR and ID SET for five
seconds. The POWER indicator on the
remote control blinks a single instance to
signify a switch from control by projector
only or control by projector to remote
control.
25. SHUTTER
The function is not available on this
projector.
26. WIRE REMOTE jack
Connect to projector for wire remote
control.
The remote control number must match the projector number for accurate control.
Introduction
13
Advertisement
Table of Contents
