Setting the lamp mode
This projector provides two lamp modes for different purposes:
Lamp mode
Normal
(The lamp is used in normal mode)
Economic
(The lamp is used in economic mode)
You can perform one of the following methods to choose a lamp mode according to your preference.
Using the remote control:
1. Press Lamp Mode on your remote control, the lamp mode page is displayed.
2. Press
to highlight your preferred lamp mode and press MODE/ENTER.
Using the OSD menu:
1. Press MENU/EXIT and then press
2. Press
to highlight Lamp Settings and press MODE/ENTER.
3. Press
to highlight Lamp Mode and press MODE/ENTER.
4. Press
to highlight your preferred lamp mode and press MODE/ENTER.
A slight variation in the picture brightness and colors may be observed during the very short time of
switching lamp modes.
User benefit
•
Delivering bright and clear images
•
Suitable for high-ambient-light environments
•
Allowing continuous and non-stop operation under
critical situations
•
Extending the lamp life
•
Allowing continuous and non-stop operation under
critical situations
/
until the System Setup: Advanced menu is highlighted.
Suitable environment
Large, well lit meeting rooms
or auditoriums
Small-mid boardrooms
Using the projector
43