Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
•
Language in the Advanced menu > System Setup: Basic menu sets your
familiar language for the OSD menus. Press OK on the projector or remote
control to display language page. Use
remote control to select your language.
•
Menu Type in the Basic menu or in the Advanced menu > System Setup:
Basic > Menu Settings menu sets the menu type. Use
preferred type.
•
Menu Position in the Advanced menu > System Setup: Basic > Menu
Settings menu sets the OSD position in five locations. Use
preferred position.
•
Menu Display Time in the Advanced menu > System Setup: Basic >
Menu Settings menu sets the length of time the OSD will remain active after
your last key press. The time length ranges from 5 to 20 seconds in 5-second
increments. Use
•
Blank Reminder Message in the Advanced menu > System Setup: Basic
> Menu Settings menu sets whether to display reminder messages on screen.
Use
/
•
Splash Screen in the Advanced menu > System Setup: Basic menu sets a
preferred logo screen to be displayed during projector start-up. Use
select a screen.
Select the lamp saver mode
1.
Open the OSD menu and go to the
Power menu.
2.
Press
from the different lamp mode,see the description list in table below.
Lamp Power
Normal
Economic
SmartEco
If the Economic mode or SmartEco mode is selected, the light output will be
reduced and result in darker projected pictures.
Operation
44
/
to select a suitable time frame.
to select your desired setting.
/
to select Normal/Economic/SmartEco. The lamp brightness vary
Description
Provides full lamp brightness
Lower brightness to extend the lamp life and decreases the fan
noise
Adjusts the lamp power automatically depending on the
content brightness level
/
/
/
and OK on the projector or
Advanced menu >
/
to select a
/
to select a
/
to
Picture > Lamp