Black & Decker PD400LG Instruction Manual page 7

iNserTiNG AND reMOviNG BiTs (fiGUre C)
• To install a hex shank screwdriver bit or
drill bit (10) simply insert it into the cavity in
the hex spindle (6) until it snaps into place as
shown in figure C.
• To remove the bit pull it straight out.
PivOTiNG THe TOOl HeAD (fiGUres D, e)
The head of the tool can be pivoted for optimum
versatility.
• Press the pivot release button (3) shown in
figure D.
• Pivot the tool head to the inline position as
shown in figure e.
• Release the button.
wArNiNG: Check to make sure tool
handle is locked after pressing pivot
release button and changing screwdriver
positions.
wArNiNG:
• To avoid being pinched at the areas indicated with black arrows, hold the screwdriver
at both ends and use your thumb to depress the pivot release button (3) when
changing positions.
• Do not use screwdriver as a pry bar in any position.
• To avoid screwdriver being turned on
accidentally, do not carry in your pocket.
fOrwArD/reverse/lOCk Off sliDer
(fiGUre f)
• To select forward or reverse rotation, use
the forward/reverse slider (2) (see arrows on
the slider).
NOTe: When the slider is in the central
position the tool is locked off to prevent
accidental actuation or battery discharge.
However, the light ring will illuminate when
the trigger is depressed.
AsseMBly AND ADjUsTMeNT
C
10
D
e
f
7
6
3
2