Troubleshooting; Battery Removal - Black & Decker PD400LG Instruction Manual

Cordless screwdriver

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Problem

• Tool will not charge.

For assistance with your product, visit our website www.blackanddecker.com for the

location of the service center nearest you or call the BLACk & DECkER help line at

1-800-544-6986.

BATTery reMOvAl

Before attempting to disassemble this tool, turn it on and run it in either direction until

it stops to ensure a complete discharge of the batteries. Using a phillips screwdriver,

remove the screws from the product housing and take the two body halves apart. Lift

the batteries out and pull off the terminal clips. See "Service Information" for battery

replacement and RBRC for battery recycling.

THe rBrC™ seAl

The RBRC™ (Rechargeable Battery Recycling Corporation)

Seal on the nickel-cadmium battery (or battery pack) indicates that the costs

to recycle the battery (or battery pack) at the end of its useful life have already

been paid by Black & Decker. In some areas, it is illegal to place spent nickel-

cadmium batteries in the trash or municipal solid waste stream and the RBRC

program provides an environmentally conscious alternative.

RBRC in cooperation with Black & Decker and other battery users, has established

programs in the United States and Canada to facilitate the collection of spent nickel-

cadmium batteries. Help protect our environment and conserve natural resources by

returning the spent nickel-cadmium battery to an authorized Black & Decker service

center or to your local retailer for recycling. You may also contact your local recycling

center for information on where to drop off the spent battery, or call 1-800-8-BATTery.

Recommended accessories for use with your tool are available from your local dealer or

authorized service center. If you need assistance regarding accessories, please call:

1-800-544-6986.

wArNiNG:

The use of any accessory not recommended for use with this tool could

be hazardous.

This Class B digital apparatus complies with Canadian ICES-003.

This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

NOTe: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.