Table of Contents
Advertisement
Super Spot LED
The optional UC-IR infrared remote (sold separately) has many dif-
fernet functions and gives you complete control of your Super Spot
LED. To control the your desired fixture you must aim the controller
at the front of the fixture and be no more the 30 feet away.
STAND BY : Pressing this button will blackout the fixture.
FULL ON : Press and hold this button for full output intensity. When
you release the button the fixture will return to its normal intensity.
FADE/GOBO : This button is invalid for the fixture.
DIMMER + / DIMMER - : Use these buttons to adjust the output in-
tensity.
COLOR : This button is invalid for the fixture.
STROBE : Press and hold this button for at least 3 seconds to acti-
vate random strobe. Press this button quickly to activate sound ac-
tive strobe.
SOUND ON & OFF : These buttons activate and deactivate the
sound active mode.
SHOW : Press this button to activate show mode.
Super Spot LED
0
1.0
Distance(m)
0.35
Diameter(m)
ADJ Products, LLC - www.adj.com - Super Spot LED Instruction Manual Page 16
UC-IR Control
Photometric Chart
1.5
2.0
3.0
4.0
0.07
0.105
0.14
Super Spot LED
Locate and remove the unit's power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry
out the fuse holder. Remove the bad fuse and replace with a new one.
The fuse holder has a built-in socket for a spare fuse be sure not to
confuse the spare fuse with active fuse.
Super Spot LED
Fixture Cleaning:
the internal and external optical lenses and mirror should be carried
out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates (I.e. smoke, fog
residue, dust, dew). In heavy club use we recommend cleaning on a
monthly basis. Periodic cleaning will ensure longevity, and crisp out-
put.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the cooling vents and fan grill.
3. Clean the external optics and mirror with glass cleaner and a soft
cloth every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
Super Spot LED
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
0m(
)
No light output from the unit;
5.0
1. Be sure the external fuse has not blown. The fuse is located on
0.175
the rear panel of the unit.
2. Be sure the fuse holder is completely and properly seated.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
ADJ Products, LLC - www.adj.com - Super Spot LED Instruction Manual Page 17
Fuse Replacement
Due to fog residue, smoke, and dust cleaning
Trouble Shooting
Cleaning
Advertisement
Table of Contents
