Error Messages - Denon AVR-2311 Owner's Manual

ENGLISH

Error messages

An error message is displayed if Audyssey ® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.
If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
Caution!
No microphone or Speaker
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
Caution!
Ambient noise is too high
or Level is too low
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
Caution!
Front R None
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
Caution!
Front L Phase
Retry
Skip
RETURN Cancel
Check cause of problem!
10
Remote control operation
buttons
Error details
• The connected setup microphone is broken,
or a device other than the supplied setup
microphone is connected.
• Not all speakers could be detected.
• The front L speaker was not properly
detected.
• There is too much noise in the room for
accurate measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• The displayed speaker could not be detected. • Check the connections of the displayed
• The displayed is connected with the polarities
reversed.
Move the cursor
(Up/Down/Left/Right)
Measures
• Connect the included setup microphone to
the SETUP MIC jack of this unit.
• Check the speaker connections.
• Either turn off any device generating noise or
move it away.
• Perform again when the surroundings are
quieter.
• Check the speaker installation and the
direction in which the speakers are facing.
• Adjust the subwoofer's volume.
speaker.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure the connection is
ui
correct, press to select "Skip", then
ENTER
press .
Confirm the setting
Parameter Check
This function enables you to check the measurement results and
equalizer characteristics after Audyssey Auto Setup.
1
Use to select "Parameter Check" and then
ui
ENTER
press .
2
Use to select the item you want to check, then
ui
press ENTER or .
p
Measurement results for each speaker are displayed.
AUTO SETUP
PARAMETER CHECK
Speaker Config Check
Distance Check
Channel Level Check
Crossover Check
EQ Check
Restore
Show speaker configuration result
Speaker Config. Check
Check the speaker configuration.
Distance Check Check the distance.
Channel Level Check Check the channel level.
Crossover Check Check the crossover frequency.
EQ Check Check the equalizer.
• If "EQ Check" is selected in step 2, press ui to select equalizing
curve ("Audyssey" or "Audyssey Flat") to be checked.
Use o p to switch the display between the different speakers.
3
RETURN
Press .
The confirmation screen reappears. Repeat step 2.
Retrieving Audyssey Auto Setup settings
If you set "Restore" to "Yes", you can return to Audyssey Auto Setup
measurement result (value calculated at the start by MultEQ ® ) even
when you have changed each setting manually.
Return to previous menu