Yeti Cycles Yeti DJ Owner's Manual page 8

Chainguide Setup

setuP Overview

The setup instructions below are only valid for a MRP chaniguide and Racface Evolve

DH cranks, for all other setups see the manufactures installation instructions. The MRP chainguide and

Raceface Evolve DH cranks are included in the DJ parts kit.

sPaCer setuP On the drive side sandwich one bottom bracket

spacer between the frame and the threaded cup.

Guide POsitiOn Slide both the top guides and the bottom guides to

the outer most position on the boomerang, and sung the bolts. The

lock ring washers go between the head of the bolt and the boomerang

and the thin flat washers are sandwiched between the guides and the

boomerang.

Guide POsitiOn Attach the boomerang to the ICMS mounts using the

flat head socket cap screws. The boomerang should be rotated so the

top arm of the boomerang is in line with the DJ seatube. You do not need

any washers between the frame and the boomerang for spacing.

setuP CHAINGUIDE

We strive to make the best bikes in the world, because of this

dedication to be the best, we continually make changes to our

bikes as needed. As the bikes are improved, assembly and

setup instructions may be affected. Any amendments to the

existing Owners Manual can be found on our website.

www.yeticycles.com

sPaCer setuP On non drive side install the threaded cup. On the

crank arm with the attached spindle install two white spacers and one

black spacer. Then lube the spindle and tap it into the threaded cups.

sPaCer setuP Once you have the spindle through both cups place

one black spacer, two white spacers, and one red spacer on the

spindle. Then attach the chainring and bashguard to the drive side crank

arm. Lube the splines and install the drive side crank arm to the spindle.

sPaCinG CheCk Once the drive side crank arm is securely fastened,

check the spacing. The boomerang rollers should be centered over

the chain and there should be the same pacing between the boomerang

guides and chain as there between the bashguard and chain.

funCtiOn CheCk Now that the setup is complete spin the cranks to

check the function of the chainguide. The rollers should move freely

and the chainline should be straight when shifted to the middle cog on the

cassette.