Kenwood BL710 series Instruction Manual page 5

Never use an unauthorised
G
attachment.
Never leave the appliance
G
unattended when it is operating.
When removing the blender or mill
G
from the power unit:
wait until the blades have
G G
completely stopped;
don't accidentally unscrew the
G G
goblet or mill jar from the blade
assembly.
Never run the blender empty.
G
Never blend more than the
G
maximum capacity stated in the
recommended speed chart.
To ensure long life of your blender,
G
do not run it for longer than 60
seconds or the mill for longer than
30 seconds.
Smoothie recipes - never blend
G
frozen ingredients that have formed
a solid mass during freezing, break it
up before adding to the goblet.
Don't use the blender as a storage
G
container. Keep it empty before and
after use.
Always use the blender on a secure,
G
dry level surface.
Never place this appliance on or
G
near a hot gas or electric burner or
where it could touch a heated
appliance.
Misuse of your blender can result in
G
injury.
This appliance is not intended for
G
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
G
ensure that they do not play with the
appliance.
Only use the appliance for its
G
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
The maximum rating is based on the
G
attachment that draws the greatest
load. Other attachments may draw
less power.
before plugging in
Make sure your electricity supply is
G
the same as the one shown on the
underside of the appliance.
Important - UK only
The wires in the cord are coloured
G
as follows:
Blue = Neutral
Brown = Live.
The appliance must be protected by
G
a 13A approved (BS1362) fuse.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
key
blender
filler cap
lid
goblet
sealing ring
blade unit
base
cord storage
speed + pulse control
power unit
vents
mill (if supplied)
mill jar
mill lid
3