Download Print this page

Kenwood BL710 series Instruction Manual page 6

Hide thumbs

Advertisement

to use your blender
1 Fit the sealing ring
unit
- ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal
G
is damaged or incorrectly
fitted.
2 Clip the blade unit
.
3 Screw the blade assembly onto the
goblet – ensuring the blade
assembly is fully tightened. Refer to
the graphics on the underside of the
blade unit as follows:
- unlocked position
- locked position
4 Put your ingredients into the goblet.
5 Fit the filler cap to the lid and push
down to secure.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the power
unit.
The appliance won't work if
G
the blender is incorrectly
fitted.
8 Plug in and select a speed (refer to
the recommended speed chart).
Select speed 1 (low) to 5 (High) by
G
turning the speed control. At the end
of blending return the speed control
to "0" before removing the blender.
(P) Pulse – operates the motor in a
G
start/stop action. The pulse will
operate for as long as it is held in
position.
hints
To blend dry ingredients - cut into
G
pieces, remove the filler cap, then
with the machine running, drop the
pieces down one by one. Keep your
hand over the opening. For best
results empty regularly.
The processing of spices is not
G
recommended as they may damage
the plastic parts.
When making mayonnaise, put all
G
the ingredients, except the oil, into
the blender. Remove the filler cap.
Then, with the appliance running,
add the oil slowly through the hole in
the lid.
into the blade
into the base
Thick mixtures, e.g. pâtés and dips,
G
may need scraping down. If the
mixture is difficult to process, add
more liquid.
to use your mill
1 Put your ingredients into the jar. Fill it
no more than half full.
2 Fit the sealing ring
unit
- ensuring the seal is located
correctly in the grooved area.
Leaking will occur if the seal
G
is damaged or incorrectly
fitted.
3 Clip the blade unit
.
4 Turn the mill blade assembly upside
down. Lower it into the jar
down. Turn in a clockwise direction
to lock.
5 Place the mill onto the power unit.
6 Select a speed or use the pulse
control (refer to the recommended
speed chart).
7 After milling, you can replace the
blade assembly with the mill lid
4
(if supplied)
into the blade
into the base
, blades
.

Advertisement

loading

  Also See for Kenwood BL710 series

This manual is also suitable for:

Bl700 series