Chapter 1: Connections & Setup; Things To Consider Before You Connect; Protect Against Power Surges; Protect Components From Overheating - RCA PHD42600 User Manual

Rca plasma monitor user's guide
Hide thumbs Also See for PHD42600:
Table of Contents

Advertisement

Things to Consider Before You Connect

Protect Against Power Surges

Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug your
monitor into an outlet that is controlled by a wall switch.
Turn off the monitor and/or component(s) before you connect or disconnect any cables.
Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your
monitor.

Protect Components from Overheating

Don't block ventilation holes on any of the components. Arrange the components so that air can circulate freely.
Don't stack components.
When you place components in a stand, make sure you allow adequate ventilation.
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won't flow around
other components.

Important Stand and Base Safety Information

If a stand or base is used insure that it is of adequate size and strength to prevent the TV from being accidentally tipped
over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safety
Instructions packed separately.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.

Use Indirect Light

Don't place the monitor where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.

Connection Illustrations

The components used in the connection illustrations are for representation only.

Receiving Channels

In order for your Plasma Monitor to display television programming, you must connect a component than can receive
programming (e.g. satellite receiver, HD receiver, or cable box).

Check Supplied Parts

Check that the following parts were
packed with your product.
Chapter 1
Chapter 1: Connections and Setup
ON•OFF
VCR
1
MONITOR
DVD
VCR
AUX
SAT•CABLE
2
MUTE
CINEMA
A
AUTO SET
GO BACK
GUIDE
INFO
OK
CLEAR
MENU
3
1
2
4
5
6
7
8
9
INPUT
ANTENNA
0
REVERSE
PLAY
FORWARD
RECORD
STOP
PAUSE
REPEAT AUDIO ANGLE OPEN
DVD
u n i v e r s a l
Remote Control
Graphics contained within this publication are for representation only.
2 AA batteries
Power cord
3

Advertisement

Table of Contents
loading

Table of Contents