Oregon CS1500-091 Original Instruction Manual page 31

OREGON® CHAIN SAW
MODEL CS1500-091
SYMPTOM
Insufficient chain
tension
Dull chain
Chain installed
backwards
Chain saw does
not cut properly
Worn chain
Dry or excessively
stretched chain
Chain not in bar groove
Bar and chain
Chain is under-
excessively hot
lubricated
and/or smoking
F/N 570773 - AC 0614
POSSIBLE CAUSE
Tension the chain See "Tensioning the Saw Chain"
in the "Preparing for Use" section of the manual
See "Sharpening with PowerSharp®"
Install the chain with the teeth facing the correct
direction See "Replacing a Worn Saw Chain and
Sharpening Stone"
Replace the chain See "Replacing a Worn Saw
Chain and Sharpening Stone"
Check the oil level Refill oil reservoir if necessary
See "Filling the Bar and Chain Oil Reservoir"
Reseat chain onto groove See "Replacing a Worn
Saw Chain and Sharpening Stone"
Check the oil level Refill oil reservoir if necessary
See "Filling the Bar and Chain Oil Reservoir"
TROUBLESHOOTING
RECOMMENDED ACTIONS
29