Download Print this page
Oregon CS1500 Quick Start Instructions

Oregon CS1500 Quick Start Instructions

Hide thumbs Also See for CS1500:

Advertisement

Quick Links

1
This sheet is meant to be a suppliment, not a replacement for your operator's manual.
After removing the chainsaw from the box, inspect it
carefully to ensure no damage has occurred during
shipping and that no parts are missing. If any parts
are damaged or missing, do not use the chainsaw.
Contact Oregon® to obtain replacement parts. For
country-specific telephone numbers, see "Customer
Service by Country".
ATTENTION!
Bar and chain oil
prevents premature wear. Never
operate the chainsaw if oil is not
visible in the inspection window.
Check oil level frequently and fill as
needed.
ATTENTION!
SAFETY NOTICE
Unplug the chainsaw
1
A
FILLING THE BAR AND CHAIN OIL
RESERVOIR
Place the chainsaw n a firm,
STEP 1:
flat surface, so that the oil cap (A) is
on top.
• Clean any debris from the cap area.
• Remove the cap.
• Carefully pour 120 ml of bar and
chain oil into the reservoir.
If the reservoir is totally full on
initial startup, it can slow down
the prime. We suggest 90% full.
CS1500 CHAINSAW
Quick Start Instructions
3
5
4
IMPORTANT
Wear protective gloves when handling chainsaw chain.
2
Loosen the side cover release
STEP 2:
knob (A) slightly. Do not fully remove
the side cover
3
Loosen the chain tensioning
STEP 3:
ring (B) by turning counter-clockwise
until it stops
4
Fully loosen the side cover
STEP 4:
release knob (A) and remove the side
cover. Remove the bar and saw chain.
ATTENTION!
Chainsaw chain is sharp,
wear suitable gloves when handling.
2
SAFETY NOTICE
BLACK
A
RED
B
BLACK
A
What's in the Box?
These items ship with the chainsaw:
1) Chainsaw
2) Guide Bar
3) Saw Chain
4) Instruction Manual
5) Blade Cover
5
ATTENTION!
SAFETY NOTICE
Plug in the chainsaw
A
STEP 5:
Re-fit the side cover and fully
tighten the side cover release knob (A).
Note bar and chain removed.
6
STEP 6:
Run the saw for around 2
minutes or until you see oil present on
the bar pad.
When the oil system has been primed
as per the above steps, unplug
the chainsaw and re-fit the bar
and sawchain as described in the
instruction manual under "Maintaining
the guide bar"
Remember to top up your bar and
chain oil regularly.
BLACK

Advertisement

loading

Summary of Contents for Oregon CS1500

  • Page 1 CS1500 CHAINSAW Quick Start Instructions What’s in the Box? These items ship with the chainsaw: 1) Chainsaw 2) Guide Bar 3) Saw Chain 4) Instruction Manual 5) Blade Cover IMPORTANT SAFETY NOTICE Wear protective gloves when handling chainsaw chain. This sheet is meant to be a suppliment, not a replacement for your operator’s manual.
  • Page 2 CS1500 CHAINSAW Quick Start Instructions TENSIONING THE SAW CHAIN IMPORTANT: The saw chain must be properly tensioned before using. BLACK ATTENTION! SAFETY NOTICE Unplug the chainsaw ATTENTION! SAFETY NOTICE Wear Chainsaw Protective Gloves Loosen the side cover release STEP 11: knob slightly, but do not remove the side cover.