Oregon CS1400 Quick Start Instructions

What's in the Box?
These items ship with the chainsaw:
1) Chainsaw Powerhead
2) Saw Chain
3) Guide Bar
4) Chain Tensioning Gear,
O-ring and Screw
5) Bar Cover
6) Instruction Manual
After removing the chainsaw from the box, inspect it
carefully to ensure no damage has occurred during
shipping and that no parts are missing. If any parts are
damaged or missing, do not use the chainsaw. Contact
Oregon® to obtain replacement parts. For country-specific
telephone numbers, see "Customer Service by Country".
Bar and chain oil
ATTENTION!
prevents premature wear. Never
operate the chainsaw if oil is not
visible. Check oil level frequently and
fill as needed.
ATTENTION! SAFETY NOTICE
Unplug the chainsaw
1
A
FILLING THE BAR AND CHAIN OIL
RESERVOIR
STEP 1: Place the chainsaw upright on
a firm, flat surface.
• Clean any debris from the cap area.
• Remove the cap.
• Carefully pour 120 ml of bar and
chain oil into the reservoir.
If the reservoir is totally full on
initial startup, it can slow down
the prime. We suggest 90% full.
CS1400 ASSEMBLY INSTRUCTIONS.06.08.2019.indd 1
CS1400 CHAINSAW
Quick Start Instructions
1
4
6
IMPORTANT SAFETY NOTICE
Wear protective gloves when handling chainsaw chain.
ATTENTION! SAFETY NOTICE
Plug in the chainsaw
2
STEP 2: Run the saw for around 2
minutes or until you see oil present on
the bar pad.
ATTENTION! Remember to top up
your bar and chain oil regularly.
3
ASSEMBLING THE GUIDE BAR AND
SAW CHAIN
STEP 3: Fully loosen the side cover
release knob (A) and remove the side
cover.
2
3
5
4
STEP 4:
(A), attach the bar and chain to the
chainsaw ensuring the mounting stud
goes through the chain tensioner (B)
and the chain is located over the drive
sprocket (C)
ATTENTION!
are facing the correct direction (D).
5
BLACK
A
STEP 5:
sure the chain catcher and side cover
tab are seated in their proper locations
(A), then tighten the side cover release
knob (B).
This sheet is meant to
be a suppliment, not a
replacement for your
operator's manual.
C
B
A
First fully loosen tensioner
D
Make sure the cutters
BLACK
B
A
A
Install the side cover, making
06/08/2019 13:25:41