Safety Screen Installation; Standard Flush Door; Dc Spark Igniter Battery Installation - Regency Fireplace Products U32 Owners & Installation Manual

installation
|
16
SAFETY SCREEN INSTALLATION / REMOVAL
1. To remove mesh barrier, open bottom louver by flipping the door
down. Grasp screen and pull towards you, lift up and remove.

STANDARD FLUSH DOOR

The standard flush door comes with a black frame. To install the frame, simply
hook the top door flange onto the top of the unit and swing the door towards
the unit, (Diagram 1 and 2). Be careful that the glass gasket does not roll up;
there must be a gap between the gasket and the door lip to ensure that the
door sits securely on the unit. Refer to Diagram 3.
Screws
Diagram 2
16 |
U32-10 Regency Direct Vent Gas Insert
®
Diagram 1
Diagram 2
Diagram 3
2. To install, reverse Steps 2-1.
Use the hook to pull the spring out until you can put the hook into the slot on
the bottom door bracket. Repeat for 2nd spring. See diagram 3.
To remove the flush door, reverse the above steps.
NOTE: The chain must rest on TOP of the gas inlet pipe never under it.
DC SPARK IGNITER BATTERY
INSTALLATION
Install the supplied battery into the DC Sparker Box
by opening the battery compartment.
NOTE: The battery in the DC Sparker Box will
need to be replaced annually.
Diagram 4
Diagram 4