BT DIVERSE 1010 User Manual page 33

The symbol is flashing or you cannot link
up with the base unit
Is the handset registered with the base unit?
To register the handset, see page 24.
Is the power cable connected at the base and
the power switched on at the wall socket?
If you press the
PHONE
flashing, you will hear four short beeps from
the handset.
Please note: If you go out of range of a base unit
for a long time while your handset is switched ON,
it may take more than 20 minutes to 'find' the base
station again when you come back within range.
However, by simply switching the handset OFF for
a moment, then ON again, it will find the base
station within a few seconds.
The base unit or handset does not ring
The ringer volume may be set too low, or
switched off at the base unit. To adjust the
ringer volume at the handset, see page 11.
Can't get through, even though a dialling
tone can be heard
You may be set to the wrong signalling
method. To change between TONE and
PULSE dialling. See Setting Up, page 9.
button whilst is
When connected to a PBX:
You can't get a connection or you get the
wrong connection after speed dialling
Have you entered an access code? See page 22.
Check you have selected the correct recall and
dialling modes. See page 9.
Handset beeps
Are the handset batteries low? You will hear a
beep every 30 seconds.
If is flashing (see previous page), you will
hear four short beeps when you press the
button. Check you are still in range of
PHONE
your base unit.
Buzzing noise on my Radio/TV, Answering
machine
Diverse is too close causing interference.
Move it further away.
If you are still experiencing difficulty, please call
the Diverse 1010 Helpline on 0345 908070.
Help
31