At the base unit:
Press and hold down the green paging
•
button until you hear the beeps (after about
10 seconds).
You now have up to 1 minute to register the handset,
during which the beeps will continue.
At the handset:
PWR
Press and hold down the button number
•
or
to specify the base unit number.
3
4
At the same time, hold down the
•
until the display shows.
2
Enter the system code.
•
(Factory setting is 0000.)
Press the # button the beep stops after a
•
few seconds, the display shows all available
handset numbers.
2 3 4 5 6
Enter the single digit internal number – from
•
to
– for the additional handset.
2
6
It is now registered.
•
If the maximum number of handsets are already
registered with the base, three dashes will appear in
the display after you enter the system code.
To set/clear the display of the base unit
number on a handset
The factory setting is to display the number.
This is useful if your handset is connected to
more than one base unit.
STO
Press the
•
Press the
•
The current setting is displayed.
Press the
•
number.
or
Press the
•
2,
display the base unit number.
Press the
•
button
PWR
Operating with additional
button.
STO
button then the
button.
3
6
button to display the base unit
1
button if you do not want to
0
button to confirm.
STO
base unit
27