Upnp Always Failed; Camera Can Not Connect Wireless; Default Parameters; Specification - Foscam FI9805P User Manual

6.1.8 UPnP always failed

UPnP only contains port forwarding in our recent software. Sometimes, it may be failed to do port forwarding
automatically because of firewall or anti-virus software. It also has much relation with router's security settings.
So we recommend you do port forwarding manually. You can view your camera in internet successfully after
you do port forwarding manually in your router.

6.1.9 Camera can not connect wireless

If your camera could not connect wireless after you set wireless settings and plug out the cable. Please check
whether your settings are correct or not.
Normally, camera can't connect wireless mainly because of wrong settings.
Make sure broadcast your SSID; use the same encryption for router and camera.

6.2 Default Parameters

Default network Parameters
IP address: obtain dynamically
Subnet mask: obtain dynamically
Gateway: obtain dynamically
DDNS: Embedded FOSCAM DDNS Service
Username and password
Default username is admin with a blank password

6.3 Specification

Specification
Image Sensor
Audio
Video
Video
Foscam Digital Technologies LLC
Telephone: 1-800-930-0949
Image Sensor High Definition Color CMOS Sensor
Display Resolution 1.3 Megapixels
Lens f : 4mm
Mini. Illumination 0 Lux (With IR Illuminator)
Linear Input/Output, which can realize two-way voice the
Input/Output
intercom
Image Compression H.264
Image Frame Rate 25fps(50Hz), 30fps(60Hz),Down adjustable
Resolution 960p(1280 x 960), 720p(1280 x 720), VGA(640 x 480)
View H.264 dual streaming
Image adjust The brightness, contrast, saturation, chromaticity, is adjustable
Infrared mode Off & Manually
Night visibility Φ8mm 36 IR LEDs, Night visibility up to 30 meters
www .foscam.
www .foscam.
FI9805P
us
us
69