Enabling Tpm Support In The Bios - Cisco c240 Installation And Service Manual

Chapter 3 Maintaining the Server
Figure 3-32
1

Enabling TPM Support in the BIOS

After hardware installation, you must enable TPM support in the BIOS:
Note
Enable TPM support:
Step 1
a.
b.
c.
d.
e.
f.
Step 2 Verify that TPM support is now enabled:
a.
b.
c.
d.
e.
Continue with
Step 3
OL-32474-01
TPM Socket Location on Motherboard
TPM socket location on the motherboard
(under PCIe riser 2)
Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Log in to the BIOS Setup Utility with your BIOS Administrator password.
On the BIOS Setup Utility window, choose the Advanced tab.
Choose Trusted Computing to open the TPM Security Device Configuration window.
Change TPM SUPPORT to Enabled.
Press F10 to save your settings and reboot the server.
Watch during bootup for the F2 prompt, and then press F2 to enter BIOS setup.
Log into the BIOS Setup utility with your BIOS Administrator password.
Choose the Advanced tab.
Choose Trusted Computing to open the TPM Security Device Configuration window.
Verify that TPM SUPPORT and TPM State are Enabled.
Enabling the Intel TXT Feature in the BIOS, page
Installing or Replacing Server Components
Riser 2
Riser 1
–
3-68.
Cisco UCS C240 M4 Server Installation and Service Guide
1
3-67