Table of Contents
Advertisement
Under "Network Delay, Packet Loss Test", you can check
the connection to another device, such as a computer
('pinging'). Enter the network address of the device to be
checked (e.g. 192.168.0.25) and click on Test.
Information on two parameters will appear:
Parameter
Setting
Average
The time the pinged device needs to
delay
reply.
Packet loss
Displays the percentage of packets
rate:
that were not transmitted.
Note
If the packet loss rate is high, we recommend that
the "Network Delay, Packet Loss Test" is
repeated.
Note
If the packet loss rate is still high, you should
check that the network cables are correct and not
damaged.
The higher the packet loss rate, the poorer the
connection between the pinged device and the
recorder.
Under "Network Packet Export", you can export the
settings of the individual connections or, depending on
the setting,
the connection.
1. For "Device Name", select a storage medium to save
the settings to.
2. Click on Export.
55
After the progress display finishes and initialisation is
successful, an information window will appear. Close
it by clicking on OK.
Click on Status to display the status of the LAN
connections (connected/not connected).
Click on Network to change your network settings.
Network Stat. tab
The bandwidth used by the device is displayed under this
tab.
You can refresh the data by clicking on Refresh.
HDD Detect
Click on the "HDD Detect" submenu.
This submenu gives you the option to check your hard
disk drive for errors.
HDD
Selection of the hard disk drive to
be processed
Self-test Status
Shows the status of the current self-
test
Self-test Type
Select the type of self-test
Short Test/Expanded
Test/Conveyance Test
S.M.A.R.T
Click on the icon to start the self-
test
Maintenance
Advertisement
Table of Contents
