Settings; Setting The Camera Output - Abus TVVR35002 User Manual

Live view

Settings

Note
The following settings are available for the live
view.
Open the main menu and click on Configuration. Then
click on Live View:
The following settings are available in the General tab:
Video Output VGA/HDMI
Interface
Select the connection where the
settings are changed.
Live View Various camera layouts
Mode
1x1, 2x2, 1+5.
Dwell Time Switching time between the
individual cameras during auto-
switch.
Enable Audio Activates the audio output
(VGA/HDMI/BNC) for the live view.
Output
Show Status Bar Activate/deactivate the status bar.
Event Output Allocate monitor for the output of
events.
Full Screen The number of seconds for which
the event will be displayed on the
Monitoring Dwell
allocated monitor.
Time
Post Event The number of seconds for which
the pop-up window should be
Display Time
displayed in the event of an alarm.
Note
VGA monitor connected:
If a VGA monitor is connected, it will be
recognised automatically when the device is
started up. The main video signal will be displayed
on the monitor.
20
No HDMI monitor connected:
If no HDMI cable is connected to the monitor
when the device is started up, the main video
signal will be emitted at the main VGA connection.
Connect the VGA cable and restart the recorder to
perform automatic detection.

Setting the camera output

You can display a maximum of five cameras
simultaneously in the live view.
1. Click on the View tab:
2. Select the display mode.

1 x 1

2 x 2

1 + 5
3. Use the navigation keys to allocate the camera
signal required to the corresponding screen section.

The X setting means that this particular camera
is not being displayed.
4.Click on Apply to apply the setting.