Lexmark MS810 Series User Manual page 83

Using MS810de
The staple, hole punch finisher must not be combined with any other output options.
• In a configuration with three optional finishers, the output expander and mailbox may be installed in any order.
•
In a configuration with two optional finishers:
–
The staple finisher must always be on top.
–
The high‑capacity output expander must always be at the bottom.
– The output expander is the only option that can be placed on top of the high‑capacity output expander.
• When using optional trays:
–
Always use a caster base when the printer is configured with a 2100‑sheet tray.
–
The 2100‑sheet tray must always be at the bottom of a configuration.
–
A maximum of four optional trays may be configured with the printer.
–
The optional 250‑ and 550‑sheet trays may be installed in any order.
Using the printer control panel
Use the
1 Display
2 Home button
3 Sleep button
4 Keypad
5 Stop or Cancel button Stop all printer activity.
6 Indicator light
1
7
To
•
View the printer status.
•
Set up and operate the printer.
Go to the home screen.
Enable Sleep mode or Hibernate mode.
Do the following to wake the printer from Sleep Mode:
•
Press any hard button.
• Pull out Tray 1 or load paper in the multipurpose feeder.
•
Open a door or cover.
•
Send a print job from the computer.
•
Perform a power‑on reset with the main power switch.
• Attach a device to the USB port on the printer.
Enter numbers, letters, or symbols.
Check the status of the printer.
2
3
4
5
6
83