Lexmark MS810 Series User Manual page 284

Troubleshooting
Close rear door
Close the rear door of the printer.
Complex page, some data may not have printed [39]
Try one or more of the following:
• From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen
printer models, press
• Cancel the current print job. For non‑touch‑screen printer models, press
•
Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of any of the following possible changes in the printer:
• The printer firmware has been updated.
• The tray for the print job is removed.
•
The print job is sent from a flash drive that is no longer attached to the USB port.
•
The printer hard disk contains print jobs that were stored when the hard disk was installed in a different printer
model.
From the printer control panel, select Continue to clear the message. For non-touch-screen printer models, press
to confirm.
Defective flash detected [51]
Try one or more of the following:
•
Replace the defective flash memory card.
•
From the printer control panel, select Continue to ignore the message and continue printing. For non‑touch‑screen
printer models, press
•
Cancel the current print job.
Disk must be formatted for use in this device
From the printer control panel, select Format disk to format the printer hard disk and clear the message.
Note: Formatting deletes all the files stored in the printer hard disk.
Disk near full. Securely clearing disk space.
Try one or more of the following:
• Select Continue to clear the message. For non-touch-screen printer models, press
•
Delete fonts, macros, and other data stored in the printer hard disk.
to confirm.
to confirm.
to confirm.
to confirm.
284