Introduction; Intended Use; Indications For Use; Contraindication - DeVilbiss IntelliPAP DV55 Bilevel S CPAP Series User Manual

Intellipap positive airway pressure device
Table of Contents

Advertisement

Available languages

Available languages

Never rinse or place the device in water. Never allow liquids to get into or around any of the ports, switches or air
filter; doing so will result in device damage. If this occurs, discontinue use and remove the power cord from the
power source. Allow the device to completely dry before use.
Do not place the IntelliPAP where it can be knocked onto the floor or where the power cord may create a trip hazard.
Only the DeVilbiss DV5 series Heated Humidifier system is recommended for use with the IntelliPAP. Other
humidifier systems may prevent the device from detecting snoring and may cause inappropriate pressure levels in
the mask.
Empty and dry humidifier water chamber before transporting.

iNTrODUcTiON

intended Use

The DeVilbiss IntelliPAP model DV55 S Series and DV56 ST Series Bilevel is intended for use in treating OSA in
spontaneously breathing patients 30 kg (66 lbs) and above by means of application of positive air pressure. The device is
to be used in home and clinical environments.
indications For Use (Optional Heated Humidifier)
Use on the advice and prescription of a licensed physician to help relieve the symptoms of dryness of the throat, nasal
passages and the mouth, which are common with positive airway pressure therapy. This is especially true in dry climates
and during the cold season when humidity in the air is typically lower than at other times.
contraindications
Positive airway pressure therapy may be contraindicated in some patients with the following pre-existing conditions:
• severe bullous lung disease
• pneumothorax or pneumomediastinum
• p athologically low blood pressure, particularly if associated with intravascular volume depletion
• dehydration
• cerebrospinal fluid leak, recent cranial surgery or trauma

KeY FeaTUreS

DeVilbiss intellipap Device (Figures a
and B)
1.
Keypad/LCD Display (see Figure C)
2.
Air Supply Port on Back
3.
Air Supply Port on Bottom (for optional humidifier)
4.
Air Supply Port Plug
5.
Heater Power Connector (for optional humidifier)
6.
AC Power Connector
7.
DC Power Connector
8.
Data Port
9.
Power Cord (appropriate to your wall outlet) (not
shown)
10. Air Inlet Filter Opening
11
Connector Cover (not shown)
Keypad (Figure c)
1.
On/Off
2.
Previous Item
3.
Next Item
4.
Delay
5.
Decrease Value
6.
Increase Value
7.
Heater Power LED (for optional humidifier)
Ask your equipment provider for information about other
DeVilbiss masks, equipment, and accessories.
A-DV56
(page 2, Figures a-F)
Humidifier cradle (Figure D)
1.
Heater plate
2.
Heater power connector
3.
Storage compartment for connector cover (on
bottom)
4.
Air supply port inlet
5.
Air supply port outlet
6.
Flow generator release button
7.
Flow generator locking tabs
Water chamber (Figure e)
1.
Chamber lid
2.
Chamber base
3.
Heat transfer plate (on bottom)
4.
Sealing gasket
5.
Water level indicators (front and sides)
6.
Chamber release latch
7.
Chamber disassembly lever

Therapy Management System

(Figure F)
1. SmartLink
(optional)
®
eN - 5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Intellipap dv56 bilevel st cpap series

Table of Contents