Page 1
ELECTRIC FIREPLACE HEATER I N S T R U C T I O N M A N U A L W913T-33BK NDF-QC913 ATTENTION: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before you...
S A F E T Y I N S T R U C T I O N S IMPORTANT SAFETY INSTRUCTIONS WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAU- TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE FOLLOWING: IMPORTANT 2) This electric fireplace heater is hot when...
Page 3
S A F E T Y I N S T R U C T I O N S 8) Do not run cord under carpeting. Do not 16) Do not plug this product into a receptacle cover cord with throw rugs, runners, or controlled by a wall switch or dimmer.
Page 4
S A F E T Y I N S T R U C T I O N S be used if a three-slot grounded receptacle is available. A 15 AMP circuit is required to operate this heater. If the breaker trips when the heater is used then you may need to move the heater to another location or un- plug other appliances that are on the same...
A S S E M B LY I N S T R U C T I O N S PARTS LIST: gently tap them into place with a hammer, until the flange of the wall anchor is flush with the Fireplace wall surface.
A S S E M B LY I N S T R U C T I O N S hold down the button - the flame optics will go higher or lower. Once you have found the desired setting, release the button. Pressing the button again will stop the light function.
A S S E M B LY I N S T R U C T I O N S The unit will beep, the pilot light and indica- tor light will be on. The fireplace heater will give low heat level. Pressing once again will stop the low heat level function.
C L E A N I N G / W A R R A N T Y Step 3: Remove the log set bed — you will cleaning to reduce the risk of fire, electric find the 2 x 40 Watt type B-10 bulbs. shock or damage to persons.
The company’s sole obliga- tion is to repair or replace the unit. This war- ranty is void if in the opinion of Quality Craft the unit has been tampered with, altered, misused, damaged, abused or used with the wrong power source.
Need help?
Do you have a question about the W913T-33BK and is the answer not in the manual?
Questions and answers