Table of Contents
Related Manuals for Quality Craft M850P-26FDC
Summary of Contents for Quality Craft M850P-26FDC
- Page 1 ELECTRIC FIREPLACE HEATER I N S T R U C T I O N M A N U A L M850P-26FDC NDF-62N ATTENTION: 1. Find a location for the fireplace heater that is protected from direct sunlight. 2. Do not plug the unit into the power outlet before you...
-
Page 2: Important Safety Instructions
S A F E T Y I N S T R U C T I O N S IMPORTANT SAFETY INSTRUCTIONS WHEN USING ELECTRICAL APPLIANCES, BASIC PRECAU- TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PERSONS, INCLUDING THE FOLLOWING: IMPORTANT 1) Read all instructions before using this... - Page 3 S A F E T Y I N S T R U C T I O N S 8) Do not run cord under carpeting. Do not No.14 AWG minimum size and rated not cover cord with throw rugs, runners, or less than 1875 watts.
- Page 4 S A F E T Y I N S T R U C T I O N S a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. A 15 AMP circuit is required to operate this heater.
-
Page 5: Parts List
A S S E M B LY I N S T R U C T I O N S PARTS LIST: Fireplace insert A) Top panel B) Base panel C) Upper front panel D) Lower front panel E) Left front panel F) Right front panel G) Left upper side panel H) Right upper side panel... - Page 6 A S S E M B LY I N S T R U C T I O N S Fig. C Step 4: Attach LOWER FRONT PANEL [D] to the unit as shown in Fig. D with 2 KD Fig. A SCREWS.
-
Page 7: Fireplace Insert Installation
A S S E M B LY I N S T R U C T I O N S Step 6: Attach TOP PANEL [A] on top with 3 KD SCREWS. See fig. F Fig. G Step 2: Attach fireplace insert into the unit as shown in Fig. -
Page 8: Operation
O P E R A T I O N WALL ANCHOR OPERATION SAFETY CABLE The use of WALL ANCHOR SAFETY CABLE After reading complete instructions, confirm is highly recommended in order to reduce all controls on fireplace are in the OFF posi- the risk of the fireplace being tipped over tion. -
Page 9: Maintenance
M A I N T E N A N C E O/I: Press this button for main power and REPLACING THE FLAME flame effect. The indicator light will turn on. EFFECT LIGHT AND See below for other control switches. LOG-SET LIGHT BULBS 1250W: For heat function - Press this switch while the O/I switch is in the ON position. - Page 10 R E P A I R S E T REPAIR SET OPTION 1: Use the spare KD NUTS, KD SCREWS and PLASTIC CONNECTOR. 1. Place the PLASTIC CONNECTOR on the mantel unit and mark the drill-holes as shown in Fig. B. TOUCH UP REPAIR PAINT Paint directly on the mantel unit if necessary.
- Page 11 R E P A I R S E T / C L E A N I N G fig. E fig. G fig. H OPTION 2: 3. Attach the SMALL L-BRACKET and lock Use the SMALL L-BRACKETS and in place with SCREWS as shown in Fig. H. SCREWS.
-
Page 12: Warranty
The company’s sole obligation is to repair or replace the unit. This warranty is void if in the opinion of Quality Craft the unit has been tampered with, altered, misused, damaged, abused or used with the wrong power source. Light bulbs are not covered by this warranty.