Installing The Cover - IBM 8849 Service Manual

7. If you are instructed to return the cover and bezel, follow all packaging

Installing the cover

To install the cover and bezel, complete the following steps:
1. Make sure that all internal cables are correctly routed.
2. Set the cover on top of the server so that approximately 13 mm (0.5 inch)
3. Slide the cover forward and into position.
4. Slide the server into the rack.
5. To install the bezel, if it was removed, tilt the bezel and align the latches with
a. Press the release latches on the inside of both front corners of the server.
b. Tilt the bezel forward and pull it away from the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
extends from the rear.
the slots at each front corner of the chassis; then, straighten the bezel and snap
it into place.
Chapter 4. Removing and replacing server components
73