4.12.2 Access Management
Configure access management table on this page. The maximum entry number is 16. If the application's type match any one of
the access management entries, it will allow access to the switch. The Access Management Configuration screen in
4-12-2
appears.
Figure 4-12-2: Access Management Configuration Overview Page Screenshot
The,page includes the following fields:
Object
Mode
Delete
VLAN ID
Start IP address
End IP address
HTTP/HTTPS
SNMP
TELNET/SSH
Buttons
: Click to add a new access management entry.
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
User's Manual of WGSD / WGSW Layer 2+ Series
Description
Indicates the access management mode operation. Possible modes are:
Enabled: Enable access management mode operation.
Disabled: Disable access management mode operation.
Check to delete the entry. It will be deleted during the next apply .
Indicates the VLAN ID for the access management entry.
Indicates the start IP address for the access management entry.
Indicates the end IP address for the access management entry.
Indicates the host can access the switch from HTTP/HTTPS interface that the
host IP address matched the entry.
Indicates the host can access the switch from SNMP interface that the host IP
address matched the entry.
Indicates the host can access the switch from TELNET/SSH interface that the
host IP address matched the entry.
274
Figure