Mldv2 Information - Planet WGSD-10020 Series User Manual

4.8.15 MLDv2 Information

Entries in the MLD SFM Information Table are shown on this page. The MLD SFM (Source-Filtered Multicast) Information Table
also contains the SSM (Source-Specific Multicast) information. This table is sorted first by VLAN ID, then by group, and then by
Port. Different source addresses belong to the same group are treated as single entry. Each page shows up to 99 entries from
the MLD SFM Information table, default being 20, selected through the "entries per page" input field. When first visited, the web
page will show the first 20 entries from the beginning of the MLD SFM Information Table.
The "Start from VLAN", and "group" input fields allow the user to select the starting point in the MLD SFM Information Table.
The MLDv2 Information screen in
The page includes the following fields:
Object
 VLAN ID
 Group
 Port

Mode
 Source Address
 Type
 Hardware Filter/Switch
Buttons
Auto-refresh : Automatic refresh occurs every 3 seconds.
: Refreshes the displayed table starting from the input fields.
: Updates the table starting from the first entry in the MLD SFM Information Table.
: Updates the table, starting with the entry after the last entry currently displayed.
Figure 4-8-18 appears.
Figure 4-8-18: MLD SSM Information Page Screenshot
Description
VLAN ID of the group.
Group address of the group displayed.
Switch port number.
Indicates the filtering mode maintained per (VLAN ID, port number, Group
Address) basis. It can be either Include or Exclude.
IP Address of the source. Currently, system limits the total number of IP source
addresses for filtering to be 128.
Indicates the Type. It can be either Allow or Deny.
Indicates whether data plane destined to the specific group address from the
source IPv6 address could be handled by chip or not.
User's Manual of WGSD / WGSW Layer 2+ Series
178