Table of Contents
Advertisement
SECTION 3 –
DRIVING YOUR MOTORHOME
•
Tip the seat rearward until the lock pin clears
the floor plate locking ramp, then re-lock the
Locking Arm to avoid bending.
•
With the seat tilted slightly rearward, remove
the seat assembly by lifting it up and forward.
Installing Companion Seats
The following label is located on the
Companion Seats:
WA RNING
Engage rear hooks in floor plate with
locking arm captured by safety lock.
Failure can result in death or injury. Refer
to operator manual.
3-2
•
With the seat tilted slightly rearward, lower
the Pedestal/Seat Assembly Rear Hooks into
the pockets in the floor plate.
Floor Plate
•
Push DOWN on the Safety Lock and rotate
the Locking Arm COUNTER-CLOCKWISE
(to the unlocked position). Align the lock pin
to allow it to pass through the floor plate at the
locking ramp.
•
Push DOWN on the front of the seat and rotate
the Locking Arm slightly to ensure that the
lock pin is engaged under the locking ramp.
•
Rotate the Locking Arm CLOCKWISE (to
the locked position), ensuring the Locking
Arm is captured by the Safety Lock.
Rear Hooks
(insert into
floor plate
pockets)
Advertisement
Table of Contents
