Table of Contents
Advertisement
•
Press the Slideout Room "RETRACT/IN"
switch and hold until the room is fully
retracted, then release the switch.
•
To stop retracting the room during operation,
release the button.
•
After the room is retracted, Remove and
Securely store the Ignition Key.
SLIDEOUT ROOM – EXTREME
WEATHER PRECAUTION
Certain extreme weather conditions, such as
heavy rains, heavy snow, and high winds, or any
combination of these, could cause damage to the
slideout room cover-awning (if equipped) or
reduce effectiveness of the slideout room weather
seals.
Slideout Cover-Awning
-Typical View
Also, freezing rain and snow can prevent the
slideout cover-awning (if equipped) from closing
and may cause damage to the cover-awning,
slideout room, weather seals, and mechanisms.
To avoid potential damage, we recommend
retracting your slideout room during extreme
weather conditions.
SLIDEOUT EMERGENCY
RETRACTION (MODEL 70C)
These instructions supersede those found in
the Power Gear Electric Driven Room Slide
Operation Manual for "Manually Overriding
Your System".
SLIDEOUT ROOMS
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch, you may need to disconnect the
motor/gear assembly and manually push the
room in to the travel position.
The motor/gearbox unit is located behind the
access panel underneath the slideroom.
Retraction Procedure
1. Remove lower closeout panel.
2. Remove protective shroud around slideout
room shaft.
3. Disengage the motor brake, which appears as
a flat "square" protrusion on the protective
boot at the end of the motor. Move the brake
lever slightly - about 1/8 turn counter-
clockwise, or to left when facing end of motor.
4. Disconnect the motor power lead from the
wiring harness.
SECTION 10 –
10-3
Advertisement
Table of Contents
