Expansion Board - HP ProLiant DL180 Gen9 Service Manual

Install the heatsink:
6.
Position the heatsink on the processor backplate.
a.
Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
b.
Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
7.
Install the access panel.
8.
Do one of the following:
9.
Slide the server into the rack.
o
Install the server into the rack.
o
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Press the Power On/Standby button.
12.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.

Expansion board

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
Removal and replacement procedures 61