Two-Slot And Three-Slot Pcie Riser Boards - HP ProLiant DL180 Gen9 Service Manual

Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the PCI riser cage
5.
Disconnect any internal cables that are connected to the expansion board.
6.
If you are removing a storage controller board with a cache module installed, remove the cache module
7.
("FBWC
Remove the expansion board.
8.
To replace the component, reverse the removal procedure.

Two-slot and three-slot PCIe riser boards

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
4.
Remove the PCI riser cage
5.
("Access
("Remove the PCI riser
module" on page 45).
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Access
("Remove the PCI riser
panel" on page 37).
cages" on page 29).
panel" on page 37).
cages" on page 29).
Removal and replacement procedures 62