Table of Contents
Advertisement
Software configuration
Easy way with installer program
In order to configure Video Servers remotely, administrators should keep the serial numbers of the new
Video Servers for identification and initial passwords. After successfully mounting Video Servers in the
proper position, run the Installer program on the appropriate PC to locate the newly installed Video
Servers. Video Servers also support manual setup procedures to non-Windows based environments. The
manual procedure is described next.
After the POST is done, Video Server will try to configure itself by detecting the network environment. If
there is DHCP service over the network, the Installer program will catch the given information and
display the serial number and given IP address for each Video Server as following figure. If no DHCP
service is available, a previous IP address will be displayed instead. In that case, it may be 0.0.0.0 for a
brand new unit. When multiple units are mounted, there may be several entries shown in the window.
Administrators may click on each entry with "Assigned" field labeled "No" to install sequentially.
10
Advertisement
Table of Contents
