Settings; Setting Water Hardness; Setting Coffee Temperature - Krups ESPRESSERIA AUTOMATIC User Manual

Connect the appliance to
the mains power supply
but do not turn it on.
Appliances are
pre-set in the factory
for hardness level 3.
Appliances are
pre-set in the factory
to 2, average
temperature.
Press the steam key to
switch to coffee
temperature setting =>
SETTING THE AUTOMATIC ELECTRICAL POWER SUPPLY CUT-OFF (AUTO-OFF)
Appliances are
pre-set in the factory
to 1 hour.
Press the steam key to
switch to automatic
cut-off setting =>
At each stage you can memorise settings by pressing the
flash twice) or continue the procedure. If no other setting is made in the next 30 seconds, the lights will go off and the
settings shown will be recorded. The settings will remain memorised even if there is a power failure.
You can change these settings at anytime by repeating the same operations.

SETTINGS

Open the servicing
flap.

SETTING WATER HARDNESS

The "water tank" light
will come on.
SETTING THE COFFEE TEMPERATURE
The 'calc' light will
come on.
The 'clean' light will
come on.
The digital display for
parameter setting is
under the servicing flap.
Press the key as
many times as are
needed to select the
hardness level for the
water used.
Press the key as
many times as are
needed to select the
desired coffee temperature.
Press the key as
many times as are
needed to select the
desired duration.
key if you have finished setting satisfactorily (the 4 lights will
4
Press the 'Service' and
keys at the same
time.
0 = very soft
1 = soft
2 = moderately hard
3 = hard
4 = very hard
1 2 3
1 = 1 H
2 = 2 H
3 = 3 H
4 = 4 H