Date & Time - Fiat Connect Nav+ User Manual

The display will show the following
string:
"Insert Setup CD to change language
of messages and voice commands.
Press ESC to cancel".
If the Setup CD is inserted the fol-
lowing message will be permanently
displayed:
"System will be unavailable for a few
seconds and calls in progress will be
terminated. Press ENTER to continue
or ESC to cancel".
If the knob 15-fig. 1 has been
pressed, the following message will be
displayed permanently:
"Message and voice command lan-
guage change in progress. Do not turn
off system. Please wait".
The end of the procedure is indicat-
ed by the following message:
"Message and voice command lan-
guage change concluded correctly".
150
If some errors occur during language
updating, the following message will be
displayed:
"Language change failed. Please re-
peat procedure".
This message asks the user to repeat
the above procedure.
Whenever the system is switched on
turning the ignition key to ON, the
language module is checked and if the
system finds a fault the following mes-
sage is displayed:
"Voice commands and messages not
available. Please change the language".
This message asks the user to repeat
language change procedure.
The user shall set again the desired
language in the SETUP menu and then
follow the above procedure.
DATE & TIME
To open the relevant screen page,
press one of the keypad keys 16-
fig. 1 under DATE fig. 162.
IMPORTANT Any adjustment can
only be performed with ignition key at
ON. Otherwise setting is rejected and
the warning message "Setup change
failed" will be displayed.
Time displaying can be set accord-
ing to two modes: 12h or 24h.
Date & Time
DATE & TIME
LANGUAGE DATE & TIME VEHICLE
fig. 162
F0Q3113g
Date and time
SYSTEM