Description - Hilti ST 2500 Original Operating Instructions

2. Description

2.1 Use of the tool as directed
The ST 2500 is a hand-held, electric mains-powered tool
for driving screws used to fasten sheet metal in metal
construction applications.
The SD 2500 is a hand-held, electric mains-powered
en
tool for driving screws used in timber construction and
drywall installation applications.
The tools are used for driving or removing the recom-
mended screws in the applicable materials.
Provision has been made for use of a magazine (SMI 55
plus) with the SD 2500.
The working environment may be a construction site of
2.2 Main applications
Application
Fastening insulating material to trapezoidal profile
steel sheeting
Fastening wood to metal
Steel grade: ST 37 to 12 mm
Steel grade: ST 52 to 8 mm
Sheet metal to sheet metal
Sheet metal to steel profile
Sheet metal on wood
Fiber-cement board to steel profile
Fiber-cement board to wood
Sandwich panel to steel profile
Sandwich panel to wood
Fastening:
– Wood to wood
– Wood to chipboard
– Chipboard to wood
Screws of up to 140 mm in length
Fastening:
– Drywall panel (plasterboard) to wood
– Drywall panel (plasterboard) to metal profiles (≤ 2.25 mm)
– Metal profiles to metal profiles
total clamping thickness 2.5 mm)
Items supplied as standard equipment (ST 2500):
– ST 2500 electric screwdriver
– S-GT17 depth gauge (for screws with sealing wash-
ers of up to 17 mm diameter)
– Operating instructions
– Toolbox or cardboard box (depending on version)
Items supplied as standard equipment (SD 2500):
– SD 2500 electric screwdriver
– Depth gauge
– Belt hook
– S-BHP 75 M and Bit S-B PH2 bit holders
– Operating instructions
– Toolbox or cardboard box (depending on version)
12
Printed: 08.07.2013 | Doc-Nr: PUB / 5070745 / 000 / 01
any kind where metal construction, timber construction
or drywall installation work is taking place.
Only the specified screwdriving bits, magazine and acces-
sories may be used with the tool. The general safety pre-
cautions listed in the operating instructions must be
observed.
The tool is intended for professional use.
The tool may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must be
informed of any special hazards that may be encoun-
tered.
Screw type / dia. in mm
Insulation screws with drill point,
type S-ID, type S-IS with point
Screws with self-drilling "wing"
point (type S-WW)
S-MD / 4.2 dia.
S-MD / 4.8 dia.
S-MD 51 + S-MD 21 / 5.5 dia.
S-MD 53 + S-MD 23 / 5.5 dia.
S-MP 53 / 6.5 dia.
S-FD 03 / 6.3 dia.
S-FD 01 / 6.5 dia.
S-CD 63 / 5.5 dia.
S-CDW 61 / 6.5 dia.
Wood screws
Drywall screws
Operating controls
Control switch with lockbutton
Forward / reverse pushbutton
Depth gauge adjusting ring
Recommended tool
ST 2500
ST 2500 and
SD 2500
ST 2500
ST 2500
ST 2500
ST 2500
SD 2500
SD 2500