Connecting The Power Cord - NEC EXPRESS5800/120Ld Service Manual

Connecting the Power Cord

Plug the female end of the AC power cord into the input receptacle on the rear
of the power supply cage. Plug the male end of the power cord into
NEMA 5-15R outlet for 100-120 VAC or NEMA 6-15R outlet for 200-240
VAC.
If the power cord supplied with the system is not compatible with the AC wall
outlet in your region, obtain a suitable power cord that meets the following
criteria.
The power cord must be rated for the available AC voltage and have a
!
current rating that is at least 125% of the current rating of the system.
The power cord connector that plugs into the wall outlet must be
!
terminated in a grounding-type male plug designed for use in your region.
It must have certification marks showing certification by an agency
acceptable in your region.
The power cord connector that plugs into the system must be an
!
IEC- type CEE-22 female connector.
The power cord must be less than 1.8 meters (6.0 feet) long.
!
2-16 Setting Up the System
230
B
or
115
A
A. Voltage selector switch set to 115 VAC
B. Voltage selector switch set to 230 VAC
Figure 2-8. Setting the Line Voltage