Removing The Hard Disk Drive Door - NEC EXPRESS5800/120Ld Service Manual

To install the front door:
1. Position the front door so the mounting pins of the front door are aligned
with their mounting holes on the front of the system. Slide the lower
mounting pin into its mounting hole and then slide in the upper pin.
2. Close the front door.

Removing the Hard Disk Drive Door

Perform this procedure to open and remove the hard disk drive (HDD) door
from either the rack or tower version of this system (tower system shown).
1. Power off the system and ensure the power cord is unplugged from the AC
wall outlet.
2. Open the front door as described in the previous procedure. No need to
remove the front door.
3. The HDD door is secured with two thumb lock screws. Loosen the
thumbscrews. (Figure 4-3, A).
4. To remove the HDD door, open it and lift the door. The mounting pins of
the front door disengage from their mounting holes on the front of the
system.
To install the HDD door:
1. Position the HDD door so the mounting pins of the door are aligned with
their mounting holes on the front of the system. Slide the mounting pins into
the mounting holes.
2. Close and secure the HDD door.
A
Figure 4-3. Opening the HDD Door
Dissasembly and Reassembly 4-5