Kenmore 596.7238 series Use & Care Manual page 23

3. • When changing from crushed to cubed, a few ounces of
crushed ice will be dispensed along with the first cubes.
Press and release the ice/water dispenser paddle, as
needed, to dispense water to the 1 cup fill line.
NOTE= If overfilling or spilling occurs, discard the water and
press ICE/WATER "Back" to restart the calibration process.
UUU
_4/oter Crushed Cubed
4. When 1 cup of water has been correctly dispensed into the
measuring cup, press the MEASURED FILL button under the
word "Confirm" to confirm the calibration.
A
o
A. l cup of woter
When Measured Fill calibration has been confirmed the
icons will disappear and the display will return to the home
screen.
Dispensing
Press ICE/WATER to toggle through the following choices in a
continuous loop.
• Water (default) - Dispenses water
• Cubed - Dispenses cubed ice.
• Crushed - Dispenses crushed ice
NOTES;
The word "ICE" appears on the display screen when
either crushed or cubed ice is selected.
For crushed ice, cubes are crushed before being
dispensed. This may cause a slight delay when
dispensing crushed ice. Noise from the ice crusher is
normal, and pieces of ice may vary in size.
The Water Dispenser
IMPORTANT=
• Dispense at least 1 qt (1 L) of water every week to maintain
a fresh supply.
• If the flow of water from the dispenser decreases, it could be
caused by low water pressure.
To
1.
• With the water filter removed, dispense 1 cup (237 mL)
of water. If 1 cup (237 mL) of water is dispensed in
8 seconds or less, the water pressure to the refrigerator
meets the minimum requirement.
• If it takes longer than 8 seconds to dispense 1 cup
(237 mL) of water, the water pressure to the refrigerator
is lower than recommended. See "Water Supply
Requirements" and "Troubleshooting" for suggestions.
Dispense Water (Standard)..
Select water.
2°
Press a sturdy glass against the dispenser paddle.
NOTE= While dispensing water and for 3 seconds after
dispensing has stopped, the digital display will show how
much water has been dispensed.
3. Remove the glass to stop dispensing.
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specified amount of
water with the touch of a few controls.
NOTE: The amount of water you select will be dispensed. Be
sure that the container is empty and can hold the entire volume.
If ice is in the container, you may need to adjust your selection.
1. Press MEASURED FILL to turn on the feature. When the
feature is on, the Measured Fill screen appears on the
display.
23