Advertisement
Care & Cleaning
Removing
and Replacing
the Oven
Door
The oven door is heavy.
Be careful when
removing
and lifting the door. Do not lift the oven door by
the handle.
Most oven doors contain
glass that can
break.
Read the following
recommendations:
° De net close the oven door until all the interior oven racks
are fully inserted and retracted
to the back of the oven.
* Do not hit the glass with pots, pans, or any other object.
The oven door glass may break or even break at a later
time unexpectedly.
* Scratching,
hitting, jarring
or stressing the oven door glass
may weaken
its structure causing
an increased risk of
breakage
at a later time.
* You may use a glass cleaner
on the outside of the oven
door glass. Do net spray or allow water
or the cleaner
to
enter or drip down into the oven door vents. Spray cleaner
on cloth first and then wipe the oven door clean.
* Do not use strong oven cleaners,
powders
or any harsh
abrasive
cleaning
materials
on the outside of the oven
door or glass.
* Never
clean the oven door gasket. The oven door gasket
should always
clean during the Self-clean
cycle.
To Remove
Oven
Door:
1.
Open
oven door completely
(horizontal with floor - See
Figure 1).
2.
Pull the door hinge locks on both left and right door
hinges down from the oven frame
completely
towards
the oven door
(See
Figure 2). A tool such as a small fiat-
blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - See Figure 3).
4.
Close the door to the broil stop position
(the oven door
will stop into this position
just before fully closing).
5.
With
the oven door in the broil stop position,
lift the
oven door hinge arms over the roller pins located
on
each side of the oven frame
(See Figure 4).
To Replace
Oven
Door:
1.
Firmly grasp both sides of oven door along the door sides
[Do not use the oven door handle - See Figure 3).
2.
Holding
the oven door at the same angle as the removal
position, seat the hook of the hinge arm onto the roller
pins located on each side of the oven door frame (See
Fig. 4). Also, seat the notch of the hinge arm onto the
bottom
of the slot at the same time you seat the hook.
The hook and notch of the hinge arms must be fully
seated onto the roller pins and bottom
of the slot.
3.
Fully open the oven door (horizontal with floor - See
Figure 1).
4.
Push the door hinge locks up towards
and into the oven
frame
on both left and right oven door hinges (See
Figure 2) to the locked position.
5.
Close the oven door.
Oven
door
Door Hinge
locations
with oven door
fully open
Figure |
Figure 2
Figure 3
Roller pin
Hinge arm hook
Hinge arm notch
Slot
bottom
Figure 4
35
Advertisement
