11.1. Serial Communication Setting
11.2. USB Communication Setting
11.3. TCP/IP Communication Setting
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
•
List of Terminal AT Commands
•
Records on Operation (LOG)
•
Records on Calls (example)
•
Statistics – Description
Use a full crossed (laplink) RS232 cable for serial communication.
Also set the following communication parameters:
Communication rate:
Number of bits:
Stop bits:
Parity:
Flow control:
File transmission protocol:
To establish USB communication, install the enclosed driver,
which installs a virtual COM port in the Windows system. You
can, e.g., use the HyperTerminal communication software for
communication. Set the following parameters:
Transmission rate:
Data bits:
Parity:
Stop bits:
Flow control:
To communicate with the 2N - VoiceBlue Lite gateway through
the LAN, set the LAN IP address first. To do this you need a direct
serial or USB PC connection. You can use such TELNET
supporting
programs
HyperTerminal, Putty, etc.
2N - VoiceBlue Lite
57,600 bps
8
1
none
Hardware
XMODEM
921,600 bps
8
none
1
none
for
TCP/IP
communication
as
111