In the System Configuration menu general device settings are adjusted. This menu is described in detail in the following
chapter.
Calling up and operating
the menu
Source names
menu item
Basic settings of the PDP 3000 HV
System Settings (System Configuration menu)
Briefly press the button on the remote control handset or the source
knob on the front panel to call up the menu.
When you open the menu, the following Select points appear on the screen:
Using the front-panel controls:
The select knob is used to select any item within the menu system.
To change a selected menu item, press the select knob to confirm your
choice, then adjust the value by rotating the select knob.
After making the adjustment, press the select knob again to adopt the new
setting.
Touch the source knob to quit the menu.
Using the remote control handset:
Use the / buttons to select an item in the menu.
If you wish to change a selected menu item, first press the button,
and then use the / buttons to alter it.
After making the change, press the button again to accept the new
setting.
You can press the button at any time to interrupt the process; the
change is then abandoned.
Press the button again to leave the menu.
The only available method of entering the name is to use the alpha-
numeric keypad on the remote control handset. For this reason the
appropriate menu item only appears if you call up the menu using the
button on the F3001 handset.
At this menu item you can activate and disable external sources, and assign a
plain text name to each source; this name then appears in the screen displays.
When you call up this menu item using the button, a list of all the
external sources of the PDP 3000 HV appears. Each source is followed by the
assigned name, or if you have disabled the source concerned the note
disabled
.
'
'
If you want to activate / disable a source, or change the plain text name,
navigate to the appropriate line.
To activate a source, press the button; a long press on the
button disables the source.
50