Removing And Replacing Tier 1 Crus; Removing The Blade Server Cover - IBM BladeCenter HS20 Problem Determination And Service Manual

If you have changed the configuration of the blade server or if you are installing a
different blade server from the one that you removed, you must configure the blade
server through the Configuration/Setup Utility, and you might have to install the
blade server operating system. Detailed information about these tasks is available
in the Installation and User's Guide.

Removing and replacing Tier 1 CRUs

Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.

Removing the blade server cover

To remove the blade server cover, complete the following steps.
Cover
Pins
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Carefully lay the blade server down on a flat, static-protective surface, with the
4. Press the blade-cover release on each side of the blade server and lift the
5. Lift the cover from the blade server and store it for future use.
Blade-Cover
Release
on page 55.
the blade server from a BladeCenter unit" on page 57 for instructions).
cover side up.
cover open.
Blade-Cover
Release
Chapter 4. Removing and replacing blade server components
59