Door Reversibility; Rear Spacers - AEG S53520CTW2 User Manual

Table of Contents

Advertisement

16
www.aeg.com
As the colours of the wires in the mains
lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either
with the letter "E" or by the earth
symbol
yellow.
2. Connect the wire coloured blue to
the terminal either marked with the
letter "N" or coloured black.
3. Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4. Check that no cut, or stray strands of
wire is present and the cord clamp
(E) is secure over the outer sheath.
Make sure the electricity supply voltage
is the same as that indicated on the
appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp
fuse (B). In the event of having to change
the fuse in the plug supplied, a 13 amp
ASTA approved (BS 1362) fuse must be
used.

9.4 Rear spacers

You can find the two spacers in the bag
with documentation.
1. Release the screw.
2. Engage the spacer below the screw.
3. Turn the spacer to the right position.
4. Tighten again the screws.
or coloured green and
WARNING!
A cut off plug inserted into a
13 amp socket is a serious
safety (shock) hazard. Ensure
that it is disposed of safely.
2
3
4
9.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.

9.6 Door reversibility

1. Open the door and empty the
shelves.
2. Unscrew the screws of the upper
hinge (1).
1
WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
1
2

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents