Propeller Selection - TOHATSU MX 50D2 Owner's Manual

14
INSTALLATION
Clamp Bracket
Dimensional Drawing
 Manual tilting type
3
Washer
(small diameter)
Bolt
(12mm x length 105mm)
117(4.61")
ø13
102(4.02")
ø13
Mounting bolts should be installed with the
bolt head at inside surface of the transom.
Mounting bolts installed with the threaded
end at the inside surface of the transom
can cause personal injury.
Washer
(large diameter)
Nut
234(9.21")
Top of transom
117(4.61")
39(1.54")
25(0.98")
64(2.52")
25(0.98")
89(3.50")
204(8.03")
102(4.02")
222(8.74")
26(1.02")
248(9.76")
CAUTION

2. Propeller Selection

A propeller must be selected so that the
engine rpm measured at wide open throt-
tle while cruising is within the max. operat-
ing range; 5,150 to 5,850 rpm
For genuine propellers, refer to PROPEL-
LER TABLE (p. 57).