Advanced Options Menu; Instance; Restore Defaults - Lowrance LMS-522c iGPS Installation And Operation Instructions Manual

2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the fuel flow you want to rename and press
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENTER
flow. Press
ENT
To select a Location:
1. Press
MENU| MENU
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
menu will appear.
4. Select
L
OCATION
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press
will appear: Are you sure you wish to change this device's configuration?
5. Select
Y
ES
main display.

Advanced Options menu

The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.

Instance

The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your GPS or sonar/GPS unit.
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.

Restore Defaults

The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults. If, for example, you exe-
cute the Restore Defaults command from your Port Fuel Flow Ad-
and press
S
US ETUP
and use ↑ ↓, ← → to input the desired name for the fuel
. Press
EXIT
, use ↑ ↓ to select
and press
S
US ETUP
and press
and press
ENT
, which will open the Bus Configu-
ENT
repeatedly to get back to the main display.
NMEA 2000
, which will open the Bus Configu-
ENT
ENT
, which will open the Location menu
ENT
. Press
EXIT
214
ENT
and press
. The Device Configuration
. The following message
ENT
repeatedly to get back to the
. The Device
. The
ENT