Section 4: Sonar Options; Asp™ (Advanced Signal Processing) - Lowrance LMS-522c iGPS Installation And Operation Instructions Manual

Section 4: Sonar Options

ASP™ (Advanced Signal Processing)
The ASP™ feature is a noise rejection system built into the sonar unit
that constantly evaluates the effects of boat speed, water conditions
and interference. This automatic feature gives you the best display pos-
sible under most conditions.
The ASP feature is an effective tool in combating noise. In sonar terms,
noise is any undesired signal. It is caused by electrical and mechanical
sources such as bilge pumps, engine ignition systems and wiring, air
bubbles passing over the face of the transducer, even vibration from the
engine. In all cases, noise can produce unwanted marks on the display.
The ASP feature has four settings — Off, Low, Medium and High. If
you have high noise levels, try using the "High" ASP setting. However,
if you are having trouble with noise, we suggest that you take steps to
find the interference source and fix it, rather than continually using
the unit with the high ASP setting.
There are times when you may want to turn the ASP feature off. This
allows you to view all incoming echoes before they are processed by the
ASP feature.
Sonar Menu with Sonar Features highlighted (left). Sonar Features
menu (right) with Noise Rejection (ASP) set to default low setting.
To change the ASP level:
1. From the Sonar Page, press |↓ to | .
MENU S F ENT
ONAR EATURES
2. Press ↓ to | .
N R ENT
OISE EJECTION
57