Related Manuals for Horizon Hobby UMX Whipit
Summary of Contents for Horizon Hobby UMX Whipit
- Page 1 ™ ™ Whipit Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni...
-
Page 2: Safety Precautions And Warnings
Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury. -
Page 3: Table Of Contents
Table of Contents Transmitter Setup ..........4 Limited Warranty ..........11 Wing Installation ............4 Warranty and Service Information ......12 Transmitter and Receiver Binding ......5 FCC Information ...........12 Flight Battery Installation and Receiver Arming ..6 IC Information ............12 Center of Gravity (CG) Adjustment ......7 Compliance Information for the European Union ...13 Control Direction Test ..........7 Replacement Parts ..........47... -
Page 4: Transmitter Setup
Transmitter Setup Dual Rates To obtain the best fl ight performance, we Dual Rate recommend using a DSM2/DSMX radio capable of adjustable Dual Rates. The suggested settings High shown here are the recommended starting settings. Elevator 100% Adjust according to the individual preferences after the initial fl... -
Page 5: Transmitter And Receiver Binding
Transmitter and Receiver Binding Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) ™ code of a single specifi c transmitter. You need to ‘bind’ your chosen Spektrum DSM2/DSMX technology equipped aircraft transmitter to the receiver for proper operation. Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. -
Page 6: Flight Battery Installation And Receiver Arming
Flight Battery Installation and Receiver Arming Arming the receiver also occurs after binding as previously described, but subsequent connection Apply hook and of a fl ight battery requires the following steps. loop tape to the battery. It is normal for linear servos to make noise. Noise is not an indication of a faulty servo. -
Page 7: Center Of Gravity (Cg) Adjustment
Center of Gravity (CG) Adjustment The CG location is 36mm back from the leading edge at the wing root. This CG location has been determined with the recommended 1S 150mAh 3.7 Li-Po battery installed in the battery cavity located on the bottom of the aircraft. -
Page 8: Control Centering
Control Centering Before the fi rst fl ights, or in the event of an crash, make sure the fl ight control surfaces are centered when the transmitter controls and trims are neutral. The transmitter sub-trim must be set to zero. Adjust the linkages mechanically if the control surfaces are not centered. -
Page 9: Flying Tips And Repairs
Flying Tips and Repairs Consult local laws and ordinances before choosing causing one side of the airplane to rise, rather than a location to fl y your aircraft. the entire airplane. Enter the thermal by turning your aircraft directly into it, circling to stay in the We recommend fl... -
Page 10: Post Flight Checklist
Post Flight Checklist 1. Disconnect the fl ight battery from 4. Recharge the fl ight battery. the receiver (Required for safety and 5. Store the fl ight battery apart from the battery life). aircraft and monitor the battery charge. 2. Power OFF the transmitter. 6. -
Page 11: Limited Warranty
What this Warranty Covers from state to state. Horizon reserves the right to change or modify this warranty at any time without notice. Horizon Hobby, LLC. (“Horizon”) warrants to the original purchaser that the product purchased (the “Product”) will WARRANTY SERVICES... -
Page 12: Warranty And Service Information
+44 (0) 1279 641 097 CM18 7NS, United Kingdom Horizon Technischer Service service@horizonhobby.de Christian-Junge-Straße 1 Germany 25337 Elmshorn, Germany Sales: Horizon Hobby GmbH +49 (0) 4121 2655 100 infofrance@horizonhobby.com Service/Parts/Sales: 11 Rue Georges Charpak France Horizon Hobby SAS 77127 Lieusaint, France +33 (0) 1 60 18 34 90 info@horizonhobby.com.cn... -
Page 13: Compliance Information For The European Union
European Union (in accordance with ISO/IEC 17050-1) No. HH2014122205 This product must not be disposed Product(s): E-fl ite UMX Whipit of with other waste. Instead, it is the DLG BNF Basic user’s responsibility to dispose of their Item Number(s): EFLU3150... -
Page 14: Replacement Parts
Tail Set: UMX Whipit UMX Whipit: Leitwerk Empennage: UMX piani di coda: UMX EFLU3103 Whipit Whipit Nose Cone: UMX Whipit UMX Whipit: Nasenkonus Cône de nez: UMX cono di punta: UMX EFLU3104 Whipit Whipit EFLU3101 Fusleage: UMX Whipit UMX Whipit: Rumpf... - Page 15 © 2015 Horizon Hobby, LLC. E-fl ite, Whipit, Celectra, UMX, DSM, DSM2, DSMX, ModelMatch, Bind-N-Fly, the BNF logo and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.